How To Measure Ring Size

Before you can use the charts below, you’ll need to know how to measure your ring size. Take the steps below to measure your ring size, using millimetres.

  1. Take a piece of string or a piece of paper (no wider than 1.4cm or ½ inch), as this will help you to be accurate.

  2. Wrap it around the base of the finger you would like to measure.

  3. Use a pen to mark the point on the string or paper where it overlaps. The overlap will form a complete circle.

  4. Take a ruler and measure the length of the string or paper from the starting end, to the end you marked with the pen.

  5. Finally, use this measurement and compare it against the chart below to determine your UK ring size.

Tips for measuring your ring size

  • Measure when your fingers are at their largest - usually at the end of the day.

  • Make sure you can comfortably slide the string or paper over your finger joints/knuckles.

  • Measure your finger 3 or 4 times to make sure you’re getting a correct reading.

  • Use a few different pieces of paper or string too - these materials can twist or stretch so it’s best to take a few readings.

 

Measuring Your Finger Using Our Ring Sizer Chart

If you’d prefer not to measure your ring size using the tips above, simply download our ring sizer chart here. Here’s how to use it:

 To guarantee that your ring measurements are perfectly precise, ensure that page scaling is set to ‘None’ when you print it off. Use A4 paper.

 Then, double check you’ve printed the chart correctly by measuring the line on the right. This will show you whether or not scaling has occurred.

 Take a ring that fits on the desired finger and place it over the circles on this chart.

 Line up the ring by placing it in such a way that the inside edge of the ring matches the circle nearest in size. This measurement will reveal the diameter of the ring.

 If the ring falls between two sizes, order the larger size. (Remember you may be able to order a half or quarter size).

 If you want to find a measurement of an existing ring, you can use the chart below as a template. Simply place the ring over the circles and whichever your ring sits nicely on is the right size. Note: the line should be tightly aligned with the inside of the band. 

ring size chart.png

Please use the below ring size chart and converter to work out your ring sizes

ring size converter.jpeg

** We highly recommend that you visit a local jeweller to have your finger professionally measured, and try on rings of the same width before ordering from us.